Extra Rinse; Temperature Selection - Hoover HL4 1272D3 Manual De Instrucciones

time the button is pressed, until h24
appears on the display, at which point
pressing the button again will reset the
delay start to zero.
- Confirm by pressing the START/PAUSE
button. The delay countdown will begin
and when it has finished the programme
will start automatically.
l
It is possible to cancel the delay start by
turning the programme selector to OFF.
If there is any break in the power supply
while the machine is operating, a special
memory stores the selected programme
and, when the power is restored, it
continues where it left OFF.
The option buttons
selected before
START/PAUSE button.
OPTIONS button
This button allows you to choose between
three different options:

- EXTRA RINSE

l
This option allows you to add one rinse at
the end of the washing cycle and is useful
for people with delicate and sensitive
skin, for which a small amount of
detergent residue can cause irritations or
allergies.
l
It is advisable to also use this function for
the children clothes and for the washing
of heavily soiled items, which requires a
lot of detergent to be used, or for the
washing of toweling items whose fibres
mostly have the tendency to hold the
detergent.
- HYGIENE +
Activated when
temperature. This
cleaning of your clothes by maintaining the
same temperature for the whole wash.
should be
pressing the
you set 60°C
option allows deep
- EASY IRON
This function allows you to minimizes
creases as much as possible, eliminating
the intermediate spins or
intensity of the last one.
If an option is selected that is not
compatible
programme then the option indicator
light first flashes and then goes off.
RAPID / STAIN LEVEL button
This button allows you to choose between
two different options, depending on the
selected programme.
- RAPID
The button
you select the RAPID (14/30/44 Min.)
programme on the knob and allows you to
select one of three durations indicated.
- STAIN LEVEL button
l
Once the programme has been selected
the wash time set for that programme will
be automatically shown.
l
This option allows you to choose between
3 levels of wash intensity modifying the
length of the programme, depending on
how much the fabrics are soiled (can only
be used on some programmes as shown
in the table of programmes).

TEMPERATURE SELECTION

button
l
This button allows you to change the
temperature of the wash cycles.
l
It is not possible to raise the temperature
over the maximum allowed for the
programme, in order to protect the
of
fabrics.
l
If you want carry out a cold wash all the
indicators must be off.
57
reducing the
with the selected
becomes active when