T
:
HIS KIT CONTAINS
• 1 W
ALL EXTENSION
• 1 P
(
ARTS BAG
SERVICE PART NO
1
, 8
. 8
5/8"
WIRE CLAMP
NO
X
2
8
. 10-32
WASHERS AND
NO
F
OLLOW HOOD INSTALLATION GUIDE STEPS
PRIOR TO WALL EXTENSION INSTALLATION
Due to the weight of this hood, ensure that the wood strip is
attached to all of the available studs (2 studs minimum for
36" width hood and 3 studs minimum for 48" or 60" width
hood); not into the wall alone.
Measure and mark a
level line on wall above
cooktop location for the
wood mounting strip.
Remove wood mount-
ing strip from back of
hood.
Center wood mounting
strip over location.
Use no. 10 x 2'' flat
head screws to secure
the mounting strip to
the wall.
Make sure to hit the
wall studs.
Insert house wiring through top, right hole.
Rest the back cavity of the wall extension on wood mounting
strip (provided with the hood). Secure upper portion of the wall
extension to wood mounting strip with (up to) 6 no. 8 x 5/8"
screws (included).
Drill two 3/16" diameter holes into the wall for wall anchors
through two of the existing lower holes of the wall extension.
Then, install both wall anchors, both washers and 2 no. 8 x 5/8"
screws (included).
4
6 S
TO
HD0475
2 W
ALL ANCHORS
. S97018867)
INCLUDING
, 2
SCREWS
WALL ANCHORS
3/8"
X
SCREWS
CAUTION
HD0478A
1. Wall
4. Wall anchor location
2. Wood mounting
5. Back of wall
strip
extension outline
3. Flat head screw
6. Wall studs
CREWS
/
/
WASHERS
SCREWS
W
E
ALL
XTENSION
I
NSTALLATION
Using pliers, unfold to 90° both wall extension metal tabs to
align hood during installation.
:
,
1
3
TO
.
HR0071
W
HEN INSTALLING WITH
F
OLLOW HOOD INSTALLATION GUIDE STEPS
W
HEN INSTALLING WITH
F
OLLOW HOOD INSTALLATION GUIDE STEP
Remove the hood
electrical compartment
and insert house wiring
through hood wire
clamp.
Rest the back cavity of
the hood on wall
extension metal tabs.
Secure hood to wall
extension using 8
provided no. 10-32 x
1/2" quadrex screws (4
on both sides). See
illustration at right.
Tighten wire clamp.
W
HEN INSTALLING WITH
F
OLLOW HOOD INSTALLATION GUIDE STEPS
W
HEN INSTALLING WITH
F
OLLOW HOOD INSTALLATION GUIDE STEPS
AWWPD S
I
NSTRUCTIONS
90°
T
AB
WPD38
BEFORE INSTALLING HOOD
WPD39
BEFORE INSTALLING HOOD
S
CREW
LOCATIONS
WPD38
TO FINALIZE HOOD INSTALLATION
WPD39
TO FINALIZE HOOD INSTALLATION
ERIES
:
MODELS
5
7
TO
.
:
MODELS
5
.
:
MODELS
10
12
TO
.
:
MODELS
8
12
TO
.