Introduction; Installation - Emerson SOLAHD STF Serie Manual De Instalación

EnglishVersion

Introduction

Notes / Notas / Remarques
The Sola Active Tracking Filter STF Series offer the original Active
®
Tracking technology to guard against commonly occurring, but very
damaging, lower energy transients and offers excellent noise reduction.
The filter continuously track the input power line sinusoid responding
instantly into action upon detecting extraneous input high
frequency noise.

Installation

!
DANGER
ONLY QUALIFIED PERSONNEL SHOULD INSTALL OR SERVICE
THIS SYSTEM. ELECTRICAL SAFETY PRE-CAUTIONS MUST BE
FOLLOWED WHEN INSTALLING OR SERVICING THIS EQUIPMENT. TO
PREVENT RISK OF ELECTRICAL SHOCK, TURN OFF AND LOCK OUT
ALL POWER SOURCES TO THE UNIT BEFORE MAKING ELECTRICAL
CONNECTIONS OR SERVICING.
Proper installation is required for maximum system performance. Read
the following information to assure a quality installation. These instructions
do not replace national or local electrical codes.
For units provided with a ground connection, a green (with or without
one or more yellow stripes) insulated grounding conductor identical in
size, insulation material, and thickness to the grounded and ungrounded
conductors must be installed (ref. NEC Table 250-95) and referenced back
to an acceptable building earth ground.
Attachment plugs, receptacles, etc. in the vicinity of the filter must be of a
grounding type, with the grounding conductors serving them connected to
an acceptable building earth ground.
Terminals, lugs, and connectors used in installation must be suitable for
the material of the conductors. Conductors of dissimilar metals shall not be
intermixed in a terminal or splicing.
- 2 - - 27 -