Application - Refco DIGIMON-SE Guía De Instalación Y Funcionamiento

Instruction Manual DIGIMON-SE / DIGIMON4

Application

Set-up

Insert 4 batteries in the battery compartment at the back of the device.
Caution: Ensure the batteries are inserted observing the correct
polarities. Do not leave empty batteries in the battery
compartment. If you will not be using the DIGIMON for a
longer period of time, remove the batteries from the battery
compartment.

Press the

Check battery charge level indicator.
Illuminating the display
LIGHT
Press the
automatically after 1 minute.
Automatic shut-off
The DIGIMON switches off automatically approximately 15 minutes after the last
measurement or after the last button has been pressed.
Resetting pressure sensors
By pressing the
reset to zero, in order to avoid incorrect measurement values.
Important note:

Depressurise the DIGIMON (remove hoses).

Open the blue and red valves.
To obtain a correct measurement value on the display, the DIGIMON
should not be reset when pressurised or under a vacuum.
ON/OFF
button, the device is now switched on.
button to switch the display light on or off. The light switches off
SET LIGHT
and buttons the DIGIMON pressure displays are
English
7