Wet/Dry Vac Assembly - RIDGID WD10500 Manual Del Proprietário

Wet/Dry Vac Assembly

Assembling the Powerhead:
1. Align the front of the Powerhead
Assembly with the Vacuum Inlet
located on the front of the Dust Drum,
as shown.
2. Place the Powerhead Assembly on top
of the Dust Drum.
3. Ensure the Powerhead Assembly
completely covers the top of the Dust
Drum so leakage does not occur.
4. Rotate the Drum Latches up and over
the Powerhead Assembly Hooks to
engage the Two Latches.
5. To remove the Powerhead Assembly,
reverse the above directions.
Insert / Remove Hose
1. Insert the Release Button end of the
Tug-A-Long Dual Flex Hose into the
Vac Inlet of the Drum. The Hose
should snap into place.
2. To Remove the Tug-A-Long Dual Flex
Hose from the Vac, press the Release
Button on the Hose Assembly and pull
the Hose out of the Vac Inlet.
3. Optional: Place the Utility Nozzle
on the opposite end of the Tug-A-
Long Dual Flex Hose, securing the
Accessory with the Tug-A-Long Dual
Flex Hose Locking Button.
The Vac is ready for use.
6