Metra INST-6000 Instrucciones De Instalación página 14

Dodge Colt 1987-1988,
Mitsubishi Mirage
1985-1988
4. Remove the dummy
cap located below the
brake lever and (2)
exposed screws.
5. Remove the screws
securing the factory
radio and disconnect
(Figure A)
the wiring. (Figure A)
6. Snap the filler bar onto
the equalizer housing
and slide the assembly
onto the bottom of
the radio housing.
(Figure B)
7. Mount bracket Set #2
(Figure B)
to the back of the e
qualizer housing with
(4) #8 x 1/2" hex-head
screws supplied.
(Figure C)
Continue to kit
assembly, p. 5.6
(Figure C)
Dash Disassembly 99-7000
Dodge Colt/Eagle Summit/Mitsubishi
1. Remove (2) Phillips screws
above the climate controls.
2. Remove (2) Phillips screws from
the bottom edge of the radio
trim bezel and remove the bezel.
3. Remove (4) Phillips securing the
factory radio and disconnect the
wiring. (Figure A)
(Figure A)
5.1
Mirage 1989-1992
4. Snap the filler bar onto the
equalizer housing and slide the
assembly onto the bottom of the
radio housing. (Figure B)
Note: The factory pocket may be
used by omitting this step and
mounting the pocket under the
radio housing during installation.
(Figure B)
5. Cut and remove all mounting
tabs on bracket Set #1 EXCEPT
tabs "B". (Figure C)
6. Mount the converted brackets to
the back of the assembly with
(6) #8 x 3/4" hex-head screws
supplied.
Continue to kit assembly, p. 5.6
"B"
(Figure C)
Mounting tab(s): identified by a
stamped letter on back of tab