Replacing The Starter Cable; Replacing The Return Spring; Replacing The Suction Head - Solo 694 Manual De Instrucciones

Replacing the starter cable

1
H
- Demount the fan housing (H/1) (4 screws).
- The cable drum must not be demounted.
- Remove the old cable.
- Mount the new cable 0.16" x 40" (ø 4x1000 mm) and tie
it up in a simple knot in the drum, and in a knot with
a loop in the starter grip. The end of the cable must not
project the drum.

Replacing the return spring

2
3
1
J
- Demount the fan housing (J/1).
- Loosen the screw with the star-shaped recess (J/2) on
the pivot.
- Pull off the pivot (J/3).
- Remove the cable drum (J/4).
- Demount the spring cover (J/5) (3 screws).
- Slightly knock the hollow side of the fan housing on
wood while holding it tightly. Thus the old spring will
jump out and release.
- The new spring is delivered in a box, under full tension.
For mounting the whole box is pressed into the fan
housing and the wire ring is stripped off (a spring which
has jumped out is remounted by turning it clockwise
into the housing).
I
- Wind the cable around the drum as far as possible. Then
pull the cable with the starter grip approx. 20" (50 cm)
out of the drum, hold the drum tightly and wind the
cable once again around the drum.
- Release the drum and let the cable wind up by means of
the spring tension. The starter grip must now stand
upright at the outside of the starter casing.
NOTE:
When the starter cable has been completely pulled
out, it must be possible to turn the cable drum
against the spring tension through 1/4 rotation.

Replacing the suction head

4
5
1
K
- Pull the suction head by means of a bent wire through
the tank opening.
- The felt filter (K/1) of the suction head can be clogged.
- It is recommended to replace the suction head once
every three months in order to guarantee an unimpeded
fuel flow to the carburetor.
43