Megger LT7 Guia Del Usuario página 5

Display:
Temperature Range:
Operating:
Storage:
Thermal Protection:
Safety: Meets the requirements for double insulation to IEC1010-1(1995)
EN61010 (1995) at 230 V installation Category III*, without the need for
separately fused test leads. If required, fused test leads are available as an
optional accessory. *Relates to transient overvoltage likely to be found in
fixed installation wiring.
Fuses:
E.M.C:
Note:
Environmental Protection:
Dimensions:
Weight:
Cleaning:
Supplied
User Guide
Power cord test lead with 3 pin plug to BS1363/A
Power cord test lead with CEE 7/7 plug
Dual test lead with probe
Test-&-carry case
Optional
Test Lead Set red/balck
Crocodile clip, black, for use with dual test lead
Earth bond test lead with probe and 3 pin plug
to BS1363/A
Fused probe and clip set (2 probes and 3 clips)
1000 V max.10A fuse
Power cord
The power cord supplied with your LT7 forms part of the measuring circuit of
the instrument. The overall length of this lead must not be altered.
If the power cord plug is not suitable for your type of socket outlets, do not use
an adaptor. You may change the plug once only by cutting the cord as close
as possible and fitting a suitable plug.
The colour code of the cord is:
Earth (Ground)
N e u t r a l
Phase (Line)
If using a fused plug, a 10 Amp fuse to BS 1362 should be fitted.
Note: Aplug severed from the power cord should be destroyed, as a plug
with bare conductors is hazardous in a live socket outlet.
3 digit L.C.D.
-5˚C to 40˚C (0 - 90% RH non Condensing)
-25˚C to 65˚C (0 - 95% RH non Condensing at
4 0 ˚ C )
Thermal cut-out will prevent overheating caused
by repetitive testing on highcurrent range.
- Internal 10A (F) 440 V 10kA ceramic HBC
- Mains power cord fused plug (when applicable):
10 Amp fuse to BS1362
In accordance with IEC 61326 including amendment No.1
Overvoltage spikes may cause a reset to the original
power 'On' state before reverting to normal operation.
IP54
220 mm x 92 mm x 55 mm
1200g (including leads, case & battery cells)
Wipe disconnected instrument with a clean cloth
dampened with soapy water or Isopropyl Alcohol (IPA).
ACCESSORIES
or
Part number
6172-087
6231-601
6231-593
6231-591
6420-092
6220-437
6280-284
6231-586
6180-405
Yellow / Green
B l u e
B r o w n