THOMSON TT400 CD Manual De Instrucciones página 18

FM STEREO RECEPTION
The FM Stereo Indicator "
"Stereo".
TIPS FOR BEST RECEPTION
FM – During FM reception, always keep the FM Wire Antenna fully extended. If FM reception is weak try
repositioning the FM Wire Antenna until you find the strongest FM signal.
At any time during playback, press the EQ key (on remote control) repeatedly to choose the desired
sound effect according to the music you are listening to:
1. Raise the Turntable Dust Cover.
2. Remove the stylus protector and release the Tone Arm Clamp (4)
3. Press the Function button(21) to "PHONO".
4. Place a record on the turntable, over the center spindle.
5. Set the Speed Selector Switch to 33, 45 or 78 rpm according to the record you
are playing. Place the included 45 RPM adaptor (5) over the center spindle when playing 45 rpm records.
6. Move the Tone Arm to the beginning of the record or to the beginning of a particular track. Gently lower
the Tone Arm onto the record to start playing. Adjust the Volume if needed. The Turntable will stop
automatically when the record finishes.
7. To stop the record before it ends, lift the Tone Arm (4) using the Cue-lever (6) and return it carefully onto
the Tone Arm Clamp (4).
8. Replace the stylus protector on the stylus when not in use.
NOTE:
i. Do not stop or turn the platter manually.
ii. Moving or jarring the turntable without securing the Tone arm clamp could result in damage to
the Tone arm.
AUTO-STOP SWITCH OPERATION
The Auto-Stop area on some records may extend beyond the preset setting. As a result the turntable could
possibly stop before the last track finishes. If you experience this during playback, set the AUTO-STOP
Selector (3) to the "OFF" position. The turntable will now run to the end of the record, but will no longer stop
automatically. To stop the turntable you will need to either Press ON/STANDBY (22) key once to turn the unit
"OFF", or return the AUTO-STOP Switch (3) to the "ON" position. After the record stops, lift and return the
Tone Arm (4) carefully back onto the Tone Arm Clamp (6).
IMPORTANT:
Moving or jarring the Turntable without securing the Tone Arm Clamp (6) could result in damage to the Tone
Arm (4).
You can convert you favorite records into MP3 files and store them on a USB Flash Drive.
Insert a USB flash drive into the USB PORT (29) located on the front panel.
1.
Press the RECORD Button (9), "WAITING" will begin in the display to CHECK THE USB
2.
CAPACITY then "REC" and "USB" will begin to flash in the display, if a USB Flash Drive is
6
" will light up when listening to a strong station that is broadcasting in
MUSIC EQUALIZER OPERATION
PLAYING PHONO RECORDS
ENCODING RECORDS TO MP3