Breaking In The Pump
1.Turn the switch to the OFF position.
2. Open the drain valve. Turn counterclockwise (loosen).
3. Plug in the air compressor and switch the power switch to the ON position.
4. The compressor will start.
Allow the compressor to run for 15 minutes, to break in the internal parts.
WARNING!
5. After about 15 minutes, turn the power switch to the OFF position.
6. Close the drain valve. Turn clockwise direction.
7. Turn the power switch to the ON position. The compressor will start and fill the tank to the kick-out pressure and stop.
WARNING!
NOTE!
WARNING!
NOTE!
Operating Instructions
Daily Startup
1. Turn the power switch to the OFF position.
2. Close the tank drain valve. Turn clockwise direction.
3. Plug in the power cord.
4. Turn the power switch to the ON position.
WARNING!
handling or servicing. Keep children away from the compressor at all times.
After about 15 minutes. If the unit does not operate properly, shut down immediately and
contact product service center 1-888-863-7589.
As compressed air is used, the pressure switch will restart the motor automatically.
During the initial break-in cycle, there will be a slight electrical smell as the motor brushes
seat.This is normal for universal motors and will last for about 5 minutes.
High temperatures are generated by the electrical motor and the pump. To prevent burns or
other injuries, do not touch the compressor while it is running. Allow it to cool before
OPERATION
14