Risk Of Electric Shock - Ford FCE6150QV Manual Del Operador

Risk Of Injury (cont)
How to prevent it:
• Never carry the tool by the hose.
• Avoid unintentional starting.
• Repair servicing should be done only by an authorized service representative.
• Never operate tool while under the influence of drugs or alcohol.
• Don't overreach. Keep proper footing and balance at all times.
• Keep handles dry, clean and free from oil and grease.
• Stay alert. Watch what you are doing. Use common sense. Do not operate tool when you are tired.
• Never use tools which have been dropped, impacted or damaged.
• Use only impact grade sockets on an impact wrench.
• Do not apply excessive force to the tool. Let the tool perform the work.
• Never point discharge of tool at self or others.
• Do not pull trigger unless tool contact safety device is against work surface.
• Never attempt to drive fasteners into hard surfaces such as steel, concrete or tile when using air tools.
• Use only accessories identified by the manufacturer to be used with specific tools.
• Maintain the tool with care.
• Keep a cutting tool sharp and clean. A properly maintained tool with sharp cutting edges reduces the risk of binding
and is easier to control.
• Check for misalignment of binding or moving parts, breakage of parts and any other condition that affects the tool's
operation. If damaged, have the tool serviced before using.
• Use of an accessory not intended for use with the specific tools increases the risk of injury to persons.
• Always shut off the compressor, remove the plug from the outlet, and bleed all pressure from the system before
servicing the compressor or when the compressor is not in use.
• Do not operate the unit with the shroud removed.

Risk Of Electric Shock

What could happen:
• Using air tools to attach electrical wiring can result in electrocution or death.
• Improper electrical connections can result in fires, electrocution, or death.
• If the tool is not provided with an insulated gripping surface, contact with a "live" wire makes exposed metal tool parts
"live", resulting in possible electrocution or death.
• Fasteners coming in contact with hidden electrical wiring could cause electrocution or death.
How to prevent it:
• Never attach electrical wiring with energized tools.
• Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased
risk of electric shock if your body is grounded.
• Thoroughly investigate the work piece for possible hidden wiring before performing work.
• A licensed electrician in accordance with all local and national codes must install all wiring.
• Never use an electric air compressor outdoors when it is raining or on a wet surface, as it may cause an electric shock.
SAFETY RULES
8