Pre-Installation Procedures; Inspection For Shipping Damage; Installation Instructions; Locating The Display Case - Federal TSSM2454SC-3 Instrucciones De Instalación Y Operación

PRE-INSTALLATION PROCEDURES

Inspection For Shipping Damage

You are responsible for filing all freight claims with the delivering truck line.
Inspect all cartons and crates for damage upon arrival. If there is damage to
shipping crates, cartons, or if a shortage is found, note this on (all copies) of
the Bill Of Lading prior to signing.
If damage is discovered when the case is uncrated, immediately call the delivering
truck line and follow-up the call with a written report indicating concealed damage to
your shipment. Ask for an immediate inspection of your concealed damaged item.
Crating material must be retained and shown to the inspector from the truck line.

INSTALLATION INSTRUCTIONS

Locating the Display Case

The case should be located where it is not subjected to the direct rays of the sun,
heating ducts, grills, radiators, or ceiling fans, nor should it be located near open doors
or main door entrances. Avoid locations where there is excessive air movement or air
disturbances and avoid high humidity locations such as near cases with water misting or
fogging devices.
The condenser air inlet is located on the top front left and right. The condenser air outlet
is located on the top and top back of the case. Do not block these vents and do not
locate the air inlet near a source of heat.
The installation clearances of the case are 2" on each of the sides, 0" on the rear of
the case, and open on the top and the front of the case.

Grill Removal

WARNING
The top discharge grill houses the condensing unit and electrical components and is
secured with self-threading screws.
This grill must be in place for safety and proper operation of the merchandiser.
Refrigerated Self-Serve Merchandiser (High Profile)
: Electrical shock hazard. Do not operate unit with panels removed.
NOTE: This case is designed for indoor use only.
Page 4