Wet/Dry Vac Assembly - RIDGID WD10600 El Manual Del Propietario

Wet/Dry vac Assembly

Assembling the Power head:
1. Align the front of the power head
assembly with the vacuum port
located on the front of the dust drum,
as shown.
2. Place the power head assembly on
top of the dust drum.
3. Ensure the power head assembly
completely covers the top of the dust
drum so leakage does not occur.
4. Rotate the drum latch up and over the
power head assembly hook to engage
the two latches.
5. To remove the power head assembly,
reverse these directions.
Inserting hose:
1. Insert the larger end of the hose into
the vacuum port.
2. Optional: Place the utility nozzle
securely on the opposite end of the
hose. The Vac is ready for use.
Power Head
Assembly
Hook
Drum
Latch
6
Vacuum
Port
Hose