Blowing Feature; Accessory Storage - RIDGID WD10600 El Manual Del Propietario

Operation (continued)

Blowing Feature

Your Wet/Dry Vac features "Full Blowing".
It can blow sawdust and other debris.
Follow the steps below to use your Vac
as a blower.
1. Locate the blowing port of your
Wet/Dry Vac.
2. Insert the larger end of the hose into
the blowing port of the Vac.
3. (Optional) Attach the extension wand
to the swivel end of the hose.
4. Turn the Vac on and you are ready to
use your Vac as a blower.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.

Accessory Storage

1. Slide the extension wands onto the
posts of the caddy feet for storage.
2. Place each accessory (utility nozzle
and wet nozzle) onto the top of each
extension wand for storage.
3. To remove wands and accessories,
lightly rotate and pull upward.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the vac/Blower for
extended time or in a noisy area.
Power Head
Assembly
Blowing
Port
Hose
10
Wet
Nozzle
Utility
Nozzle
Extension
Wands (2)
Caddy
Feet