Quiet Talk (Qt)/ Digital Quiet Talk (Dqt); Radio Access Number (Ran) - Kenwood NEXEBGE NX-740H Manual De Instrucciones

STUN
This function is used when a transceiver is stolen or lost. When the transceiver
receives a call containing a stun code, the transceiver becomes disabled. The
stun code is canceled when the transceiver receives a call with a revive code.
• "St" appears on the display while the transceiver is stunned.
SIGNALING

QUIET TALK (QT)/ DIGITAL QUIET TALK (DQT)

The Encoder/ Decoder function uses QT/ DQT to segregate talk groups, so users
only hear calls from their own group.

RADIO ACCESS NUMBER (RAN)

RAN is a signaling system designed for digital radio communications. When a
channel is set up with a RAN, squelch will only open when a call containing a
matching RAN is received. If a call containing a different RAN is made on the
channel you are using, you will not hear the call. This allows you to ignore (not
hear) calls from other parties who are using the same channel.
NXDN ID
NXDN ID is an optional signaling system available only for digital communications.
DTMF
A DTMF PTT ID is included for dispatch operations or simple remote control
applications. The DTMF decode capabilities include Selective Call ID, Transpond
with ID, and "Wild Card" Group Calling.
2-TONE
2-tone Signaling opens the squelch only when your transceiver receives a call
containing matching 2 tones.
FleetSync
Refer to "SELCALL (SELECTIVE CALLING)" on page 11.
MDC-1200
The following features are available with the built-in MDC signaling: PTT ID
Encode, Emergency Encode, Stun/ Revive Decode, and Radio Check Decode.
Note: The transceiver cannot decode MDC-1200 if the FleetSync baud rate is 2400 bps.
10