Aiwa NSX-D9 Manual De Instrucciones página 26

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The, clock is displayed. (The ":" between the hours and minutes
flashes.) When the power cord is plugged into an AC outlet for
the first time after purchase or when the clock setting is canceled
due to a power failure, the entire clock display flashes.
1
2
3
Press CLOCK.
Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
+
or ~
is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
Press ENTER or Il.
The clock starts from 00 second.
To restore an original clock setting
Press CLOCK before completing step 3 to restore the previous
time setting. This cancels any new setting.
To view the clock when another display is in the display
Press CLOCK.
The time is displayed for 4 seconds and then
the original display reappears. However, the clock cannot be
displayed during recording.
To switch to the 24-hour standard
Press CLOCK and then press
within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
If the power-economizing
mode (page 6) is on, all the display
lights turn off when the power is turned off. To view the clock,
press CLOCK so that the time is displayed for 4 seconds.
1
2
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press SLEEP.
2 Within 4 seconds,
press -
or ~
to specify
the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
MULTI JOG is also available instead of ++
and ~.
Specified time
To check the time remaining until the power is turned off
Press SLEEP once.
The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press SLEEP twice so that "SLEEP oFF appears on the display.
25
ENGLISH

Publicidad

Tabla de contenido
loading

Tabla de contenido