Basic Navigation - Hedson IRT QuickSpot 3 Manual De Instrucciones

7. Program Mode – General rules for navigation in the software
– The display shows software defined options in the bottom corner fields.
To adjust the values use the arrow keys.
–
– To move to previous display without saving, press cancel.
7.1

Basic navigation

There are nine predefined programs, see chapter 2.1.2, and six empty ones. All 15 programs have editable positions,
names and drying parameters.
Scroll up or down using the arrow keys, press select to run the program or view to edit.
7.2
7.2.1 Positioning
Place the dryer centered over the
spot repair area with the distance robs
against the object.
Stop or cancel
7.2.2 Start drying
returns to 7.1.
Press the button on the dryer handle
OR press start on the control unit to
begin the drying sequence. The re-
maining time of the "flash off" will start
counting down. When the "flash off"
is finished, the program automatically
changes to full fake mode.
7.2.3 Program values
Press view and the screen shows the
values for power (0–100 % of machine
capacity) and energy consumption of
current drying process.
7.2.4 Energy consumption
Total energy consumption per drying
process is shown for the last 10 runs.
7.2.5 Drying complete
When flash off and full bake times have
expired the software returns to 7.1.
Note! To extend the lifetime of the
lamps, the ventilators will continue to
run for cooling. After three minutes they
turn off automatically.
195996 rev 2
Run 7.3
7.3.1 Properties
The values of the chosen program will
show on the display.
Stop or cancel
7.3.2 PIN Code
returns to 7.1.
Use the arrow keys to set the correct
digit. Press enter to confirm and to edit
the second, third and fourth digit of the
advanced PIN code.
Note! An entered PIN code is valid for all
entries until the main switch is turned off.
Use arrow keys
See chapter 8.2 for advanced PIN code.
to set numbers.
7.3.3 Edit program parameters
When marked, change the value of the
parameters with the arrow keys. Press
enter to change the next value and
so on. Pressing enter for the last value
directs the user to editing of program
position and name. Press cancel to exit
without saving any parameters.
The program
returns to 7.3.1.
7.3.4 Edit program position/
name
When marked, change the program
number with the arrow keys. Press enter
to confirm and to edit the next symbol.
Note! Changing the number will also
change the program position in the
The program
program list.
returns to 7.3.1.
7.3.5 Expansion of the program
steps
When the drying process requires more
than the two standard steps, you can ex-
pand the number of steps in the drying
cycle by linking to the next program.
Start from point 7.3.4 and press enter
The program
repeatedly until the Link to next pro-
returns to 7.3.1.
gram appears on the screen. Select
with the arrow keys yes or no, and then
press save. The link to the next program
will remain until it is deactivated (no).
Use program 10-15 as these are free
programs without any default.
EN
Edit
5