Maintenance And Service; Filter Replacement - Hedson IRT QuickSpot 3 Manual De Instrucciones

Test Completed
Automatic testing is now complete. Press enter or next
to finish.
8.4.20 48 Program Time Scale
Possibility to change between minutes and seconds.
8.4.21 49 Proc. Alarm Temp.
Not applicable on this model.
9.

Maintenance and Service

Weekly
Check that all IR lamps light up during dryer operation.
Defect IR lamps can cause uneven heat distribution over
the surface.
Clean the dryer from dust, which can be a cause of fire,
with a damp cloth. Also, check that all cables are undam-
aged. A damaged cable can be a danger to life!
Monthly
Check the gold coated reflectors. Damaged or extremely
dirty reflectors can over heat the reflector body and/
or the cassette. In case of doubt, please contact the
customer service in order to clarify if the gold coated
reflector needs to be changed.
Yearly
Plan to change the air filter approx. once per year. You
will get a message in the software when it is time to
change. When starting up the dryer you will get an indi-
cation on how much of the filter time that is used.
9.1

Filter replacement

Attention!
The filters are disposable and should not be reused.
1. Use a knife or screw driver to bend loose the two
plastic plugs at the cassette side plates.
2. Remove the used filter.
3. Insert the new filter.
4. Replace the filter holder.
5. Reset the filter timer. Log into advanced settings mode
according to chapter 8.1 and 8.2. Move to parameter
45 (8.4.17) and press yes for reset the filter.
6. Picture, see chapter 11.
8
9.2 IRT lamp replacement
Attention!
Do not touch either the gold coated reflector or the new
IR lamp with your fingers. Only remove the protective
paper on the IR lamp after you have installed it.
1. Disconnect power supply.
2. Remove both cover plates.
IRT QuickSpot 3
IRT QuickSpot 6
3. Remove both lamp end protection plates.
4. Remove the mesh and unscrew the lamp from the two
ends.
5. Install new lamp in the reverse order.
EN
Rev.
1
2
3
1
Rev. Change no Change description
2 - NYTT UTSEENDE
1 - 399006
1
Material
Drawn date
2016-08-30
3
4
2
Material Surface finish Dimension
Drawn date Approved by Drawn by Designed by General Tolerance
2017-01-25 MF MF
Certified by
Description
KASSETT QUICK SPOT 6kW EXT_START
195996 rev 2
Change no
- 399006 - QUICK SPO
Appr. by Appr. date
Rev. by
HK HK 2017-09-21
MF MF 2017-01-25
Surface finish
Approved by
M
Certified by
Description
KAS
Note
Scale Sheet
ISO 2768-m 1:2 4 (4)
E
Approved date
2017-01-25
Status
Approved
Article no Rev
733150 2