Installation Instructions - Faber CLASSICA PLUS CLPL30SSV Instrucciones De Instalación Información De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
Draw a vertical line on the supporting wall as high as practical, at the center of the area in which
the hood will be installed.
Draw a horizontal line at where the bottom edge of the hood will be located as indicated in the figure
that is a minimum of 24" - 30" above cooking surface.
2
Draw a horizontal line where indicated at the bottom edge of the vent hood at the desired height above
the cooking surface.
Place a bracket 7.2.1 on the wall as shown about 1/8" from the ceiling or upper limit, aligning the
centers(notch) with the vertical reference line and mark the wall at the centers of the holes in the bracket.
Place the second bracket 7.2.1 on the wall as shown, below the first bracket, at the height of the
upper chimney section supplied and aligning the centers(notch) with the vertical line.
Mark the wall at the centers of the holes in the bracket and mark the point 1 and 2 for the Hood Body
installation as show (7 1/16" from the horizontal line and 5
Drill ø 5/16" holes at all the centers points marked (point 1,2,3,4,5,6) as shown.
8

Installation Instructions

2.1
5
1/2"
>
5
1/2"
" from the vertical line).
1/2
7.2.1
x6
x6

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Classica plus clpl36ssvClassica plusClpl30ssvClpl36ssv

Tabla de contenido