Operation - Hatco SERV-RITE SRB Serie Manual De Instalación Y Operación

General
WARNING
Read all safety messages in the iMPORtANt SAFety
iNFORMAtiON section before operating this equipment.
eLeCtRiC ShOCk hAzARD: Do not fill SRB and SRBW
models with water. they are dry heat units only, not steam
table units.
NOTICE
Do not place anything on top of glass sneeze guard. it is
not designed to be a weight-bearing component.
Do not slide pans across glass surface, use rough-
bottomed pans, or drop anything on glass surface.
Scratching or breakage may occur. Damage to glass
surface or breakage of glass caused by misuse is not
covered under warranty.
Startup
Glass
Sneeze
Guard
Model SRBW-1
BURN hAzARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
"out 1"
SET
Key
NOTE: The digital temperature controller is pre-set to a setpoint
temperature of 88°C (190°F) at the factory. Once the
setpoint temperature is changed, the new setpoint
temperature will remain in memory until it is changed
again.
NOTE: SRB and SRG series have a digital temperature
controller with a maximum setpoint temperature setting
of 104°C (220°F), but the maximum operating
temperature of the unit is 93°C (200°F). A temperature
setting above 93°C (200°F) will not harm the unit.
SRSS-1 and SRSSBW-1 models have a maximum
setpoint temperature setting of 90°C (195°F).
Removable
Utensil Tray
Overhead
Heat Lamps
Control
Panel

OPeRAtiON

CAUTION
Down Arrow
Up Arrow
Key
Key
Heated
Shelf
Model SRG-1/SRSS-1
Celsius
Symbol