AGPtek H01 Manual Del Usuario página 8

Press MFB to adjust brightness.
Note: The sensor on the back of the bracelet should
be close to your skin during monitoring. In addition,
please ensure that your skin is clean to avoid the
external environment affecting the testing results.
Warnings
• The bracelet is charged by 5V/500mA charger. Do
not charge it with the over-voltage power supply.
• If there's water on the bracelet, dry it in time.
• Working temperature is from 0 to 45 degree.
Prohibit throwing it into the fire to avoid
exploding.
• Please wipe the the sweat on your wrist in time.
Prohibit the wristband be exposed to soap, sweat,
allergen or contaminated ingredients for a long
time to prevent skin irritation.
• Do not touch chemicals such as gasoline, cleaning
solvents, propanol, alcohol or insect repellent to
prevent damage to the bracelet.
• Do not use this product in high pressure and high
magnetic fields.
FQA
• Cannot bind to the bracelet?
Please make sure your phone being power on and
active. And ensure your bracelet have not connected
to other phones. Then keep the bracelet closer to the
phone. The phone and bracelet will automatically
bind. If it still does not bind, please turn off the
phone's Bluetooth, and then restart the phone's
Bluetooth after 20s.
• Cannot bind to Phone's Bluetooth?
1. Make sure
iOS8.0/Android4.4 or above/Bluetooth 4.0.
that mobile
6
phone supports