Troubleshooting - Foster 7322 300 Manual De Instalacion Y Uso

troubleshooting

Problem
You cannot activate or
operate the appliance.
The hob deactivates.
Residual heat indicator
does not come on.
The sensor keys become
hot.
The heat setting changes
between two levels.
comes on.
12
Possible cause
The appliance
not connected
an electrical supply
or it is connected
incorrectly.
The fuse is released.
It's been more than
20 seconds from the
switching on of the
appliance.
You touched 2 or
more sensor keys at
the same time.
There is water or fat
stains
on the control panel.
You put something on
the sensor key ON-
OFF.
The zone is not hot
because it operated
only for a short time.
The cookware is too
large or you put it too
near to the controls.
Power management
function operates.
The Child Lock
function operates.
Remedy
is Check if the appliance is
to correctly connected
the electrical supply. Refer
to "Electrical connection"
chapter.
Make sure
fuse is the cause of the
malfunction.
If the fuse releases again
and again,
qualified electrician.
Activate the appliance again
and set the heat setting in
less than 20 seconds.
Touch only one sensor key.
Clean the control panel.
Remove the object from the
sensor key.
If the zone
sufficiently long to be hot
contact an
Service Centre.
Put large cookware on the
rear zones if possible.
Refer to "Using the cooktop"
chapter.
Refer to "Using the cooktop"
chapter.
to
that the
contact a
operated
Authorised