Installation; All Models; Location; Operation - Hatco GLO-RAY GRSDH Serie Manual Del Usuario

ALL MODELS

Glo-Ray Merchandising Display Warmers are shipped with most
components pre-assembled. Care should be taken when unpacking
shipping carton to avoid damage to unit and components enclosed.
1. Remove unit from box.
2. Remove information packet. To prevent delay in obtaining
warranty coverage, fill out and mail in the warranty card.
3. Remove tape and protective packaging from all
surfaces of unit.
CAUTION
The National Sanitation Foundation (NSF) requires units over
91 cm (36") in length or weighing more than 36 kg (80 lbs.)
to be either sealed or raised on the installation surface. If this
unit cannot be sealed at the point of use, 10 cm (4") legs are
included to allow for proper cleaning access below unit.
4. Carefully lay unit on its side and install the four legs as shown
in 12 .
5. Slide each side glass panel into the upper channel, then lower
the panel into the lower channel. See 9 .
5. The unit is supplied with product divider bars. To install them,
place the bars in the channels provided see 10 . The bars can
be readily adjusted to separate your holding areas as needed.
The Merchandising Display Warmer main power is controlled
by the ON/OFF toggle switches. See 7 . Each switch must
be on the ON position for the unit to function.
The thermostat controlled base can be set to any desired heating
level as indicated on the control plate.
NOTE: Main power toggle switch must be in the ON position
for the heated base to function.

GENERAL

Hatco Glo-Ray Merchandising Display Warmers are designed
for maximum durability and performance, with
minimum maintenance.
WARNING
To avoid any injury, turn the power switch off, unplug the unit
from the power source and allow to cool before performing
any maintenance.
WARNING
To avoid electrical shock or personal injury, do not steam clean
or use excessive water on the unit.
WARNING
Unit is not waterproof. DO NOT submerge in water. Do not
operate if it has been submerged in water.

LOCATION

NOTE: Unit must be transported in the upright position.
For proper operation and maximum performance, locate
the Merchandising Display Warmer in an area where the ambient air
temperature is constant and is a minimum of 21°C (70°F). Areas
which are susceptible to active air movements or currents should be
avoided, i.e., near exhaust fans or hoods and air conditioning ducts.
For safe and proper operation, the unit must be located
a reasonable distance from combustible walls and materials.
If safe distances are not maintained, discoloration
or combustion could occur.
Locate the unit at the proper counter height, in an area that
is convenient for use. The location should be level to prevent
the unit or its contents from accidentally falling, and strong
enough to support the weight of the unit and food displayed.
NOTE: If the unit is equipped with LED Temperature Controls, see
ACCESSORIES for operation.
Some exterior surfaces on the unit will get hot. Use caution
when touching these areas to avoid injury.

CLEANING

Use only non-abrasive cleaners. Abrasive cleaners could scratch
the finish of your Glo-Ray Merchandising Warmer, marring its
appearance and making it susceptible to dirt accumulation.
To preserve the bright finish of the Glo-Ray Merchandising Display
Warmer, it is recommended that the exterior and interior surfaces
be wiped daily with a damp cloth. Stubborn stains may be removed
with a good non-abrasive cleaner. Hard to reach areas should
be cleaned with a small brush and mild soap.
Clean the glass sides using a common glass cleaner.
This appliance is not of jet-proof construction. Do not use
jet-clean-spray to clean this appliance.
10

INSTALLATION

WARNING
CAUTION

OPERATION

CAUTION

MAINTENANCE

CAUTION
WARNING
Form No. GRSDCEM-1002