JB Systems Light RF-DMX CONVERTER Manual De Instrucciones página 7

ENGLISH
MODE 2: LED LIGHTS – RGB + Dimmer
This mode is used for architectural LED lighting and LED DMX projectors.
Channel 4 is limited to value 190, audio and strobe mode can't be switched
on.
This mode can be used with the Planospot, LED PAR56, LDP-powerbar,...
All connected units are addressed with address = 001
Mode2 uses sticker M2 for the transmitter, the sticker layout has the following
buttons:
1. Blackout button: switches the dimmer between 000 and last setting
before standby.
2. DIM-/DIM+ buttons: used to change the master dimmer 0-100%: CH4 =
000 to 190
3. COLOR-buttons: switches the values of RGB to get the desired colors
4. FADE-buttons:
The fade + and – buttons increase or decrease the fade speed.
Dipswitch settings: 0100
MODE 3: LED LIGHTS – RGB + Dimmer
This mode is used for LED projectors that may also go in strobe and/or sound mode. In this mode, channel 4
is NOT limited to 190, audio and strobe mode can be activated for products like the Planospot, LED
PAR56, LDP powerbar,...
Briteq architectural products could be used with this mode using the dimmer channel up to 255 without strobe
function.
Dipswitch settings: 1100
The rest is identical to MODE2.
JB SYSTEMS
®
The fade button
5/40
toggles the fade
OPERATION MANUAL
speed.
RF-DMX CONVERTER