Setup And Use - JB Systems Light RF-DMX CONVERTER Manual De Instrucciones

ENGLISH
FUNCTIONS WIRELESS TRANSMITTER
1. SEND INDICATOR: blinks while the transmitter sends commands to
the RF-receiver.
2. CONTROL BUTTONS: these 13 buttons allow the user to
independently control different light effects. Please check the chapter
SETUP AND USE for the different possible options.
3. BATTERY COMPARTMENT: the transmitter works with a small 12V
battery. (type A23 or MN21)
4. STICKER MODE: used to identify the sticker that corresponds to the
selected working mode.
RF DMX RECEIVER FUNCTIONS
1. XLR 3pin CONNECTOR: to be connected to the 3pin DMX input
on the light effects.
2. DC-ADAPTER INPUT: connect the DC-adapter here.
3. RF ANTENNA: the RF antenna receives the signal transmit by
the remote control.
4. POWER LED: is lit when the RF DMX converter is on.
5. RF-SIGNAL LED: is lit while the unit receives commands from
the wireless remote. Also used to setup the receiver, see next
chapter for more information.
6. SETUP BUTTON: the transmitter should be synchronized with
the remote control. See next chapter for further explanation.
7. DIPSWITCH: The user can set up the desired DMX mode depending on the units that will be connected
to the RF DMX converter.

SETUP AND USE:

To setup the remote control, press the setup button on the RF DMX converter, then press one key on the
remote control. This operation should be done within 5 sec. During this time, the green led (RF signal LED)
is flashing. When a key is pressed on the remote control, the green led on the RF DMX converter is flashing
one more time and stops blinking directly.
If the remote is correctly synchronized with the receiver, the RF signal LED on the receiver flashes each time
a key is pressed on the remote. If it's not working, repeat each step from the beginning.
Can be used to add wireless control to 2 types of DMX-projectors and dimmer/switch pack as well:
- Light effects using 1ch DMX mode or 1MSL, 2MSL, 3MSL or 4MSL DMX-configuration
- All LED lighting using our standard RGB+DIM DMX-configuration
Dipswitch settings:
To setup the DMX mode, the user should set the appropriate dipswitch settings to configure the receiver:
To control these units there is 6 different working modes.
JB SYSTEMS
®
(FRONT & REAR)
3/40
OPERATION MANUAL
RF-DMX CONVERTER