JB Systems Light RF-DMX CONVERTER Manual De Instrucciones página 8

ENGLISH
MODE 4: CONTROLLING DIMMER PACKS WITH UP TO 6CH
Used to control standard DMX dimmer packs with max 6 channels. Each channel of this dimmer pack uses 1
DMX channel. The RF DMX converter can control a DX626A for example.
For each of the 6 groups on the remote, the RF-DMX RECEIVER will always send out 1channel so the
connected units should be always setup with the following start addresses:

Unit1: start address = 001

Unit2: start address = 002

Unit3: start address = 003

Unit4: start address = 004

Unit5: start address = 005

Unit6: start address = 006
If you use a 6CH dimmer pack, the start address should be set at 001. Mode4
uses sticker M4 for the transmitter, buttons on the RF-remote work as follows:
1. Blackout: switches the output between 000 (output = off) and the last
value that has been set previously with the DIM+/DIM- buttons.
2. DIM+ button  as long as you press the button, the DMX-value will
increase until it reaches the maximum value of 255.
DIM- button  as long as you press the button, the DMX-value will
decrease until it reaches the minimum of 000.
Dipswitch settings: 0010
MODE 5: CONTROLLING SWITCH PACKS WITH UP TO 12CH
Used to control standard DMX switch packs with max 12 channels. Each channel of such switch pack uses 1
DMX channel. The RF DMX converter can control for example the following products:
DSP12, DSP4,...
Dipswitch settings: 1010
JB SYSTEMS
®
6/40
OPERATION MANUAL
RF-DMX CONVERTER