Ordering Replacement Parts; Bevel Cuts - EINHELL TK 202 Manual De Instrucciones

Anleitung 12-sprachig
Feed in the workpiece with two hands. Always
use the push stick (3) in the area of the saw
blade (4).
(A push stick is supplied with the saw!)
Always push the workpiece through to the end of
the splitter (5).
Caution! With short workpieces, use the push
stick from the beginning.
9.2 Cutting extremely narrow workpieces
(width less than 30 mm) (Fig. 9)
Adjust the parallel stop (7) to the width of
workpiece you require.
Use a push block (a) to push the workpiece until
its rear end arrives in the splitter zone (5).
Secure long workpieces against falling off at the
end of the cut (e.g. with a roller stand etc.)
There is no push block supplied with the saw!

9.3 Bevel cuts

Always use the parallel stop (7) when cutting bevels.
Fix the saw table in the required angle position
(see 8.3).
Move the workpiece along the parallel stop (7). In
this connection see also section 9.1 or 9.2,
depending on the width of the workpiece.
9.4 45°-cuts on small workpieces (Fig. 10)
You must always use the parallel stop (7) and the
angle stop (13) when making 45° cuts.
Mount the angle stop (13) on the parallel stop (7).
Adjust the parallel stop (7) to the required length
of the workpiece and clamp securely.
Insert the workpiece in the angle stop (13).
Switch on the saw and slide the angle stop (13)
along the parallel stop (7) toward the saw blade.
Switch off the saw when the cut is completed.
10. Maintenance
Remove dust and dirt regularly from the machine.
Cleaning is best done with compressed air or a
rag.
Never use caustic agents to clean plastic parts.
08.11.2001 13:29 Uhr Seite 15

11. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
GB
15