Ordering Replacement Parts; Disposal And Recycling - EINHELL GE-AW 1246 N FS Manual De Instrucciones

Sistema automático de bombeo de agua
Ocultar thumbs Ver también para GE-AW 1246 N FS:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 69
8.2 Cleaning the coarse fi lter insert
Clean the coarse filter insert at regular inter-
vals, and replace it if necessary.
Remove the coarse filter screw (4) and coar-
se filter (12) together with the non-return val-
ve (13) (Figure 3).
Do not use abrasive cleaning agents or petrol
to clean the coarse filter and the non-return
valve.
Clean the coarse filter and the non-return val-
ve by tapping them on a flat surface. In cases
of stubborn dirt, first clean with soapy water,
then rinse with clear water and air-dry.
Assemble in reverse order.

8.3 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
Anl_GE_AW_1246_N_FS_SPK9.indb 19
Anl_GE_AW_1246_N_FS_SPK9.indb 19
GB
10. Storage
Store the equipment and accessories in a
dark and dry place at above freezing tem-
perature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in
its original packaging.
If the pump is not going to be used for a long
time or has to be removed for the winter
months, rinse it out with water, empty it com-
pletely and allow it to dry.
The equipment must be completely drained
before it is subjected to frost.
After long stoppages, make sure the rotor
turns correctly by briefly switching the pump
on and off.
- 19 -
18.07.2019 13:10:41
18.07.2019 13:10:41

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

41.770.20

Tabla de contenido