Functional Description - Black and Decker MAX Serie Manual De Instrucciones

using identical replacement parts.
dANGeR: AddITIoNAL
WARNINGS foR moWeRS
• Avoid dangerous environment –
don't use lawn mowers in damp or wet
locations.
• don't force Lawn mower – it will do
the job better and safer at the rate for
which it was designed.
• don't overreach – Keep proper
footing and balance at all times.
• Stay Alert – Watch what you are doing.
Use common sense. do not operate
lawn mower when you are tired.
• Store Idle Lawn mower Indoors –
When not in use, lawn mower should
be stored in an indoor dry and locked-
up place – out of reach of children.
Remove safety key
• maintain Lawn mower With care –
Keep cutting edges sharp and clean
for best and safest performance.
• keep guards in place and in
working order.
• Keep blades sharp.
• Keep hands and feet away from
cutting area.
• Objects struck by the lawn mower
blade can cause severe injuries to
persons. The lawn should always be
carefully examined and cleared of all
objects prior to each mowing.
• If lawn mower strikes a foreign
object, follow these steps:
1) Stop lawn mower. Release the bail
handle.
2) Remove battery and safety key.
3) inspect for damage.
4) Repair any damage before restarting
and operating the lawn mower.
• Use identical replacement blades
only.

fuNcTIoNAL deScRIpTIoN

1. Switch box
2. bail handle
3. Upper-handle
4. lower-handle
5. Upper-handle attachment levers (2)
6. lower-handle attachment levers (2)
7. cut height adjust lever
8. grass collection bag
9. Rear door cover
10. battery port
11. battery storage compartment
12. carrying handles
13. edgeMax™
WARNING:
this product contains chemicals known to
the State of california to cause cancer,
birth defects or other reproductive harm.
Some examples of these chemicals are:
• compounds in fertilizers
• compounds in insecticides,
herbicides and pesticides
• arsenic and chromium from
chemically treated lumber
To reduce your exposure to these chemi-
cals, wear approved safety equipment
such as dust masks that are specially
designed to filter out
microscopic particles.
• The label on your tool may include the
following symbols. The symbols and their
definitions are as follows:
V ..................volts
mW..............milliwatts
nm ...............wavelength in nonometers
A ..................amperes
hz ................hertz
W .................watts
min ..............minutes
or Ac ......alternating current
or dc ...direct current
n o ................no load speed
................class i construction
................earthing terminal
...............safety alert symbol
................class ii construction
.../min or rpm...revolutions or
................. Use proper respiratory protection
................. Read instruction manual before use
................Use proper eye protection
...................Use proper hearing protection
5
9
11
12
10
12
5
Some dust created by
(grounded)
(double insulated)
reciprocation per minute
1
8
2
3
4
6
7
13