Scott Sport SCOTT Manual Del Usuario página 8

• HALO FIT SYSTEM: IF YOUR HELMET IS FITTED WITH A HALO
FIT SYSTEM, YOU CAN EASILY ADJUST THE HEIGHT WHEN
THE HELMET IS ON YOUR HEAD. IF YOUR HELMET DOES
NOT FIT YOUR HEAD COMFORTABLY WHEN IN THE MIDDLE
POSITION, THEN PUSH THE REAR OF THE FIT SYSTEM UP OR
PULL IT DOWN TO ADJUST THE HEIGHT OF THE REAR OF
THE FIT SYSTEM. THERE ARE 3 POSITIONS IN TOTAL.
• PLEASE MAKE SURE THAT EACH ARM OF THE FIT SYSTEM IS
SECURELY CLICKED INTO THE HELMET.
• V. CHECKING THE FIT OF YOUR HELMET
PRIOR TO USING THE HELMET MAKE SURE THAT IT FITS PROPERLY AND THE
STRAPS ARE ADJUSTED PROPERLY. PULL THE CHIN STRAPS TIGHT ENOUGH SO
THAT THE HELMET FITS FIRMLY. PUT THE HELMET IN THE PROPER POSITION (A)
AND LOOK AT YOURSELF IN A MIRROR TO CHECK THAT THE HELMET FITS PROP-
ERLY.
CHECKING THE FIT OF YOUR HELMET: GRAB THE HELMET WITH BOTH HANDS
WHILE IT IS SITTING FIRMLY ON YOUR HEAD AND TWIST IT LEFT AND RIGHT. IF
THE HELMET FITS PROPERLY, IT WILL MOVE ONLY MINIMALLY OR NOT AT ALL. IF
IT MOVES TOO MUCH, THEN PLEASE GO BACK TO POINTS 3 AND 4 AND REPEAT THE STEPS FOR ADJUSTING
THE FIT OF THE HELMET.
CHECKING THE STRAPS: GRAB THE HELMET WITH BOTH HANDS WHILE IT IS SITTING FIRMLY ON YOUR HEAD
AND ATTEMPT TO TAKE IT OFF BY PUSHING IT FORWARDS AND BACKWARDS USING SERIOUS EFFORT.
THIS IS IMPORTANT! IF YOU CAN PUSH YOUR HELMET SO FAR FORWARD THAT YOUR VIEW IS OBSTRUCT-
ED OR SO FAR BACK THAT YOUR FOREHEAD IS EXPOSED, THEN YOUR HELMET DOES NOT FIT PROPERLY. IF
THIS IS THE CASE, THEN PLEASE GO BACK TO POINTS 3 AND 4 AND REPEAT THE STEPS FOR ADJUSTING THE
HELMET.
WARNING! IF YOU CANNOT ADJUST YOUR HELMET SO THAT IT FITS PROPERLY IN ACCORDANCE WITH POINT
5, THEN PLEASE DO NOT USE THIS HELMET! CHOOSE ANOTHER HELMET SIZE OR ANOTHER HELMET MODEL.
• VI. HELMET WITH VISOR
SOME SCOTT HELMET MODELS ARE DELIVERED WITH DETACHABLE VISORS. TO DETACH THE VISOR FROM THE
HELMET, PLEASE FOLLOW THESE STEPS.
• FUGA PLUS HELMET, DETACH THE VISOR BY LIFTING UP THE VISOR FROM THE MIDDLE.
• BE CAREFUL: DO NOT TRY TO DETACH THE VISOR BY PULLING THE VISOR FROM THE MIDDLE. YOU COULD DAM-
AGE BOTH THE HELMET AND THE VISOR BY DOING SO. TO REATTACH THE VISOR, CENTER IT ON THE HELMET
AND PUSH THE VISOR MOUNTS BACK INTO THE HELMET.
ENGLISH - 8
A