Unit Wall Installation - BONAIRE 4500E Manual Del Proprietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BONAIRE WINDOW COOLER
Installation
Use the two 'Wall Anchors' provided to fix the cooler to the outside of the house if a 'stucco-type'
wall is being used. (Note that if the unit is not hard up against the wall, these fixing screws will go
into the spacer block (2' x 4') already installed).
For solid walls, brick or masonry, use suitable masonry lag anchors.
Place the unit in position, mark screw positions, remove unit then drill pilot holes for timber walls
(1/8" or 3.2mm).
Replace unit in window, fit screws with Washers – 3/16 x 7/16 x 20g flat

Unit Wall Installation

DO NOT
Contact a licensed contractor to have the cooler installed in an outside wall.
connect the power to the cooler until the installation is complete.
Page | 13

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

5900e

Tabla de contenido