Electrical Connection; Design And Function; Warning Notices On Device - CASO DESIGN TO 20 Manual De Instrucciones

13.5 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.
 The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the oven
or over hot or sharp surfaces.
 The electrical outlet must be protected by a 16A safety cut-out switch, separately from
other electricity consumers.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing
or damaged protective conductor.

14 Design and Function

This chapter provides you with important safety notices on the design and function of the
device.

14.1 Warning notices on device

ATTENTION
Danger due to hot surface!
There is a warning notice referring to dangers due to hot surfaces located on the back upper
side of the housing. The surfaces of the device can become extremely hot.
► Do not touch the hot surfaces of the device. Danger of burns!
► Do not set or lay any items on the device.
33