Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
S
O
5. Insert the paddles (P)
inside the drum base,
approximately at 30° towards the
right. Fasten with two sets of M10 x
20 recessed head screws, isolated
washers*, pressure washers and nuts.
CAUTION
* The insulated washers shall be set
outside the drum.
• Mount the drum cover (Q) into the frame (K) and
the support rod using four sets of M8 x 70 bolts,
washers, pressure washers and nuts.
• Place the retaining ring (U) on the ribbed side of the
bearing support from the drum axis (X).
T
8
L
4
N
M
H
R
6
7
M
Assembly
K
4. Set the frame (K) into the drum drive axis (L).
Mount the lower part of the drum (M) into the
support (H) inserting the frame (K) into the pole (N)
and placing the support axis in the bracket (O). Use a
set of M8 x 70 bolt, washer, pressure washer and nut
to secure the mount to the support pole.
Set the bracket (S) with the orientation as shown in
the graphic to fasten the support axis. Use two sets of
M8 x 20 bolts, washers, pressure washers and nuts.
Tighten so that the clamp is well fixed, but also allows
free movement of the drum.
P
6. Set the plastic gasket (T) onto the drum base
circumference matching the orifices. Fixing the gasket
with adhesive tape is recommended to facilitate the
mounting.
7. Set the drum cover (R) onto the base (M). Secure
the cover with 10 M8 x 16 bolts.
30°
X
U
5
Q
Publicidad
Capítulos
Tabla de contenido
