Parts - Truper PRETUL RECE-160P Instructivo

Assembly
8. Mount the control flywheel in the support axis (A).
Use two M8 x 20 sets of bolts, washers, pressure washers
and nuts to secure the flywheel in place.
• Secure the upper part of the paddles (P) to the drum
cover using two sets of M10 x 20 recessed head screws,
insulated washers * pressure washers and nuts.
CAUTION * The insulated washers shall
be set outside the drum.
9. Mount the base for the motor (F) on the
motor support (N) using four sets of M 8 x 70.
10. Mount the pulley (B) to the drum axis (C) as
shown in the graphic, and fasten firmly using the
allen screw that has the pulley in the flat area of
the drum axis.
B
C
N
9
F
12. Couple the pulley (B) to the motor axis (E) placing the band (D) in the outer
circumference of the pulley and the motor axis.
not work outside the slot of the pulley (B) and/or the motor axis (E). The motor base (F)
contains slotted holes that allow you to move the motor from back to front to align the
motor shaft with the pulley.
Control
flywheel
Drum angle
lock
Release
pedal
D
E
H
CAUTION
Paddles
Wheels
P
8
G
11. Mount the motor (G)
in its base (F) over the
rubber support (H)
inside the motor
E
housing. The motor
housing (E) shall be
oriented towards the
drum.
The band (D) should

Parts

Drum
Serrated rack
mechanism
A
B
D
12
F
Motor
cover
ENGLISH
9