Periodic Maintenance; Long Term Storage - Truper PRETUL RECE-160P Instructivo

Periodic maintenance

General cleansing
Oil inspection
Air filter inspection
Spark plug inspection and tightening
Spark plug replacement
Throttle system inspection and tightening*
Valve inspection and tightening*
Combustion chamber cleansing*
Fuel tank cleansing
Fuel filter cleansing*
Fuel hose replacement*
Band replacement

Long term storage

• Clean the fuel tank
• Start the motor until finishing all the fuel.
• After the fuel is consumed and the motor stops, turn off
the switch and let the motor cool-off completely (30
minutes approximately).
• Empty the pump pulling the starter six times
approximately.
• Drain oil as indicated in page 13.
• Disconnect the spark plug cable and remove it. Pour a
little less than a spoonful of clean four-cycle motor oil
through the spark plug orifice into the combustion
chamber.
• Without the spark plug in place pull the starter two or
three times to cover the inside wall of the cylinder.
• Service the spark plug as indicated in page 13.
• Clean the air filter as indicated in page 13.
• Store the cement mixer is a dry and ventilated place
under a roof and guarded against humidity.
14
ENGLISH
Each
use
Oil change
Perform cleaning
Air filter
Maintenance
Each 25 h Each 50 h
or each 3 moths or each 6 moths
Each 300 hours
Each year
* Go to a
to carry out these replacements and tightening.
Using the unit after long term storage
• Remove the spark pug from the cylinder.
• Pull the starter three to four times to clean the oil into the
combustion chamber.
• Clean the spark plug oil and set it back in the cylinder.
• Connect the spark plug cable.
• Fill up fuel and oil as described in page 10.
Each 100 . Each 250 h
or each 6 moths or each 2 years
Authorized Service Center
Change