Cold Lamination; Removing A Jammed Laminating Pouch - Easy Home OL 350-S Manual Del Usuario

13" Laminator
4. Move the multi-function switch to "O" (OFF) to switch the laminator off.
5. Let the laminating pouch cool off briefly.
Repeat the process if the laminating pouch has not adequately
adhered to the document.

Cold lamination

NOTICE!
Risk of damage!
Improper handling of the laminator may result in damage.
− After hot lamination, allow the laminator to cool down
sufficiently (approx. 20–30 minutes) before you use the
laminator for cold laminating.
− Make sure that only laminating pouches intended
specifically for cold lamination are used.
1. Move the multi-function switch
and operate it in cold mode.
The READY indicator with thermo-transfer-technology
2. Place the document that you wish to laminate between the two sides of the
laminating pouch. Ensure that it lies flush with the closed edge.
3. Insert the laminating pouch closed-edge first into the pouch infeed slot
on the back of the laminator. The heating rollers will automatically pull the
laminating pouch in and move it to the pouch output slot
the laminator. Do not use force to pull out the laminating pouch.
4. Move the multi-function switch to "O" (OFF) to switch the laminator off.

Removing a jammed laminating pouch

The laminator is equipped with an antiblocking system. If the laminating pouch
was not inserted straight or it becomes jammed in the laminator, push the
6
towards the left (see Fig. B). You can then take the laminating
ABS switch
pouch out of the laminator while holding down the ABS switch and reinsert the
document in a new laminating pouch into the pouch infeed slot
AFTER SALES SUPPORT
1 877-386-8264
USA
7
to "I" (COLD) to switch the laminator on
1
must be blue.
4
on the front of
3
.
www.monolith-support.com
USA
Operation
3
15