EINHELL 300/50 W Instrucciones De Manejo página 8

2288-Air-Tech-Kompressoren
GB
or dangerous goods, the provi-
sions of the local police authori-
ties should be complied with.
G Do not process media such as
white spirit, butyl alcohol and
methylene alcohol anywhere
near the PVC pressure hose
(reduced working life).
Operation of pressure
vessels in accordance
with the Order on Pres-
sure Vessels (§ 13)
1. Anyone who operates a pressure
vessel shall keep it in a proper
condition, run it properly, monitor
it, undertake the necessary
maintenance and repair work
immediately and take all the
safety measures necessary
depending on the circumstances.
2. The Supervisory Authority may
prescribe the monitoring measu-
res that are required in individual
cases.
3. A pressure vessel may not be
operated if it shows any defects
which could endanger employ-
ees or third parties.
4. If pressure vessels in Groups II,
IV, VI and VII show damage to
pressure-bearing walls which
cause them to be shut down in
accordance with § 13 Para.3, the
operator must inform the expert
and agree with him on the
necessary steps to be taken.
8
13.11.2001 14:18 Uhr
Starting up
Fitting the rotor wheels:
To fit the wheels, you will need a
hammer and a piece of piping with
an internal diameter of 25 mm or a
24 mm socket wrench.
First, knock a rapid fixing cap onto
one side of the axle pipe. It should
be about 8 mm onto the axle pipe.
Take care to affix the cap the right
way round. In order for the wheel to
turn on the axle properly over a
long period of time, grease the run-
ning surfaces on the axle with lubri-
cating grease.
Seite 8
Now place a wheel, domed side
outwards, onto the axle and push it
from one side of the axle stay out to
the other side of the axle stay. Now
grease the other side of the axle
too and place the wheel on it.
Finally, knock the second rapid
fixing cap onto the axle.
Do not fix the rapid fixing cap too
tightly, or the wheels will slip.
Finally, affix the cap covers onto
both wheels.
Hose coupling:
Twist the hose coupling, which
already has a sealing strip atta-
ched, onto the back of the boiler
with an SW 22 open-ended wrench.