First Use; Checking The Convection Heater And Product Contents; Basic Cleaning; Preparing For Start-Up - Easy Home CH-Y01AFT Manual Del Usuario

First use

Checking the convection heater and product
contents
NOTICE!
Risk of damage!
If you are not cautious when opening the packaging with a
sharp knife or other pointy objects, you may quickly damage
the convection heater.
− For this reason, be very careful when opening it.
1. Take the convection heater out of the packaging and check whether the
convection heater or the individual parts exhibit damages. If this is the case,
do not use the convection heater. Contact the manufacturer at the service
address specified on the warranty card.
2. Check to make sure that the delivery is complete (see fig. A).

Basic cleaning

1. Remove the packaging material and all protective foils.
2. Clean all parts of the convection heater before first use as described in the e convection heat
chapter "Cleaning." g."

Preparing for start-up

g for start-up for start
Before you use the convection heater for the first time, you must first attach use the convectio use the conve
both support feet to the housing or mount the convection heater on the wall. rt feet to the h rt feet to th
To do so, proceed as follows: ed a ed as fo
Mounting the support feet
1. Lay the convection heater with the back down on a stable table so that the
bottom edge of the housing extends slightly over the edge of the table
(see fig. C).
Several holes are located on both sides of the bottom of the housing. For the
next step, take note of the holes furthest to the inside.
2. Insert one support foot
Make sure that the two support feet are completely up against the housing
AFTER SALES SUPPORT
USA
866-235-5029
ging and check w ing and c
exhibit damages
act the manufact t
card. d.
ivery is complete ( very is complete (
g material and all p aterial and
onvection
7 in the holes on each of the two ends (see fig. C).
First use
opening opening it
dama
serviceusa@tempo.org
USA
15