Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. If necessary, remove the attached support feet
the convection heater on the wall.
2. Measure the distance between the two vertical slots in the rear panel of the
convection heater (see fig. D).
3. Mark this distance on the wall you would like to operate the convection
heater on.
Be absolutely sure to observe the specifications regarding safe distances at
the beginning of this chapter.
4. Drill two holes with a diameter of 0.31 in (8 mm) and a depth of
1.38 in (35 mm) in the wall and insert a dowel
5. Screw the brackets
with respect to one another.
Keep in mind that the brackets open outwards, that is, the mounting hole
points out and to the side.
6. Screw the two other brackets onto the bottom of the housing.
For this, insert the long side of the bracket on the back of the housing into
the slot on the bottom of the housing. Make sure that the mounting hole
points down in the process towards the ground.
7. Use a short screw
5
housing.
8. Hang the convection heater on the two brackets that are mounted on the
wall.
Make sure that the two slots in the rear panel of the convection heater hous-
e two slots in the r
ing slide into the opening on the two mounting brackets and that the con-
he opening on the
pening o
vection heater is hung so that it is straight.
ter is hung so that
ter is hung so
There must be at least 1.9 ft (50 cm) of space between the bottom edge of
ust be at least 1.9 ft
be at least
the housing and the ground.
sing and the
sing and the gro
9. On the wall, mark the center points for the mounting holes that will carry
l, ma
l, mark th
the two mounting brackets on the bottom of the housing.
nting
Take the convection heater down again and drill the two holes where the
marks are.
10. Insert one dowel in each of the holes you drilled.
11. Hang the convection heater back on the support brackets on the back of the
housing.
12. Screw the bottom brackets onto the wall with two long screws
You have successfully mounted the convection heater on the wall.
AFTER SALES SUPPORT
USA
866-235-5029
2
and
3
in place so that they are mirror-inverted
tom of the housing
ket on the back of
g. Make sure that t
ake sure that
ds the ground.
e ground.
to screw each of the mounting brackets onto the
w each of the mou
ach of the m
eater on the two b
er on the tw
wo slots in th
7
if you intend to mount
6
in each of them.
hat is, the m
at is, the m
m of the h
4
.
serviceusa@tempo.org
USA
First use
17
Publicidad
Capítulos
Tabla de contenido
