General Information; Cleaning Of The Outer Parts (Daily / Weekly); Clean The Internal Parts (Monthly); Clean The Honeycomb (Every 6-8 Months) - Arneg Francoforte Serie Guía De Instalación Y Manejo

F r a n c o f o r t e
English
Do not use - cleaners or similar products to clean the parts in methacrylate (Plexiglas)
- in powder
alcohol-based
- with granules
(Fig.20)
- either acidic or alkaline (bleach, ammonia)
- c o n c e n t r a t e s
- with unknown chemical compositi on
- abrasive products, chemical/organic solvents
- abrasive sponges, scourers, sharp tools
- aggressive solvents (aceti c acid, citric acid etc.)
21. 2 General informati on
• The surfaces to be cleaned and the detergents and water used for cleaning must not exceed a
maximum temperature of 30°C.
• Accurately dry with a soft cloth
CAUTION!
Fragile surfaces, glass. Dents, scratches, corrosion, wounds, broken glass
DO NOT aim the jet directly at the varnished or plasti cised surfaces
DO NOT apply the detergents directly onto the surfaces to be cleaned
DO NOT use steam cleaning equipment
Do not use excessive force
DO NOT bring the jet too close to the dirt. This may cause injury to the operator and conta-
minate parts that have already been cleaned, as well as the environment.
avoid detergents from coming into contact with nearby products.
CAUTION!
Floor products. Vapours. Corrosion. Breathing diffi culty.
avoid contact, inhalati on.

21. 3 Cleaning of the outer parts (Daily / Weekly)

Clean all external parts of the cabinet every week. See "General instructi ons" chapter21.2.

21. 4 Clean the internal parts (Monthly)

Refer to chapters 21.1 and 21.2follow the steps given:
Step
1 remove all goods from the cabinet
2 remove all the removable parts, such as display dishes, grid trays, etc.
3 wash with lukewarm water (max 30°C)
4 disinfect using an anti bacterial detergent
carefully clean the bott om tank, the drip, and the grid that protects the water drain, elimi-
5
nati ng all foreign bodies that have fallen through the sucti on grid lift ing the sheet of the fans
6 carefully dry using a soft cloth
i
Should you noti ce ice built up, call a specialized technician.

21. 5 Clean the honeycomb (every 6-8 months)

Step
1 remove the screw that secures the honeycomb support (Fig.21)
2 remove the honeycomb
3 follow the steps given in chapters 21.1 nd 21.2
4 reassemble the honeycomb completely dry, at the same angle
4 4
Acti on
Acti on
05060171 00 13-02-2018