Safety Warnings For Water Pressure Pumps - Truper PRE-1/6 Manual Del Usuario

Safety Warnings for
Water Pressure Pumps
• The automatic pressure pump is built with a noiseless
power motor totally coated with rotating parts generating
pressure in domestic clean water pipes. The pump doesn´t
overloads when full and requires little maintenance.
• It is mainly used to pressurize domestic use water to the
water heater and for sun heated water.
CAUTION
• The water to be pumped shall be clean,
with no solid particles, fibers or mineral or explosive
liquids.
• The pump may be used in warm regions where the water
entering into the line can be very hot (the pump is designed
to support up to 176 °F).
CAUTION
• Before setting up the pump double
check the pies system is properly connected and with no
obstructions, soldering remains or dirt.
WARNING
• The pump shall be installed in a dry,
well ventilated place to prevent electric shock caused by
water, spills or condensation. If the pump is set outdoors it
will need a protective cover.
WARNING • Do not install the pump inside the
bathroom because mist can enter into the connections
box.
be in contact with water.
• A recommendation to facilitate maintenance. Set up an
independent shut-off valve system in the pump water inlet
and outlet, a filter in the inlet pipes and a valve with
automatic air release if there is a possibility that air bubbles
build into the pipes.
• If the pump is not used long periods of time close the
inlet valve and cut the power supply.
• Temperature in the system shall not be higher than
environment temperature to prevent a short circuit caused
by humidity condensation in the pump body.
• If the environment temperature is below 32 °F discharge
all the water from the pipes to prevent freeze related
cracks.
immediately if there are particles, incrustation, obstruction
or any type of dirt present.
• The information labels adhered to the device shall not be
removed or covered. All the information about the device
that is no longer legible shall be replaced immediately.
The pump is designed to
pressurize cold and hot
water (up to 176 °F)
WARNING
• Do not allow the pump's electric parts
CAUTION • To prevent overheating stop the pump
ENGLISH 5