Preset Mapping; Program Change Enable And Current Map Status - Peavey PC 1600x Cover Manual De Instrucciones

• Foot Pedal
• Volume
• Sustain
• Reset Controllers
• All Notes Off
• Program Change
• Polyphonic Aftertouch
• Channel Aftertouch
• Pitch Bend
• System Exclusive
• System Common
• System Real-time
To set the status of a filter:
1. Press the Utility button.
2. Use the up/down buttons or data wheel to access the following page:
3. Press the right direction button once to edit the filter type. Use the up/down buttons or data wheel to display
the different filter types. The field on the right displays whether the data is filtered or passed to the
MIDI OUT jack.
4. To toggle between "pass" and "filter," simply press the right direction button while the filter type field is
active. The filter type field remains active until the left direction or Exit button is pressed.

PRESET MAPPING

In its default state, the PC 1600x™ will echo Program Changes, but not respond to them. To make it respond, you
must go to the "MAP: Curr Midi map" screen and switch on one of the three maps (instead of "Off"). Then the PC
1600x will respond to Program Changes on its MIDI IN channel ("ChIn" parameter on the first utility screen)
according to the map. Mapping allows each of the 128 MIDI program change messages (0-127) to recall any
preset or send any scene. Follow the steps below to select which preset is recalled or which scene is sent in
response to a received program change message:
1. Press the Utility button.
2. Use the up/down buttons or data wheel to access the following page:
3. First cursor right to the digit after "MAP." Editing this value selects which MIDI map will be edited. This
should not be confused with the current MIDI map described below.
4. Cursor right again to the third field which displays a preset or scene number. This is the preset number
recalled or scene sent when the program change value in the second field is received. If a preset is
selected, the bottom line will display the preset name. When a scene is selected, the associated preset
ber will be displayed.
Note: Program change maps 1 and 2 default to recall presets 0-49 with received program changes
0-49. Program change map 3 defaults to send scenes 0-99 with received program changes 0-99.

PROGRAM CHANGE ENABLE AND CURRENT MAP STATUS

The current MIDI map parameter selects which map incoming program changes will use. Incoming program
changes can be ignored completely by setting the current map number to "Off." To set the current map
number:
UTIL: Midi filter
Notes=Pass
MAP1: Prog 000->prs00
Preset name here
13
num-