Table 9: Oven Troubleshooting Chart
Oven Problem
"F" and a number appears in display and
control beeps
With a new range there is a strong odor
when oven is turned on
Control does not react when the pad is
touched
Fan is running during modes that don't
use convection
Warm air or steam escapes from oven
vent
This is a fault code. Press Off to clear the display and stop beeping. Reset
oven if necessary. If fault code remains and beep continues, record fault
code, cancel oven and call authorized service technician.
This is normal with a new range and will disappear after a few uses. Oper-
ating the self-clean cycle will also "burn-off" the smell more quickly.
Be sure that pad is clean. Touch the center of the touchpad. Use the flat
part of your finger.
On some models, the convection fan will run while the oven is preheating
for the bake mode. This is normal.
It is normal to see or feel steam or warm air escaping from the oven vent.
Do not block the vent.
Possible Causes and
Suggested Solutions
Service
English 35