Areas Of Application; Information On The Jaws; Clamping The Workpiece; Between Surfaces - Allmatic NC8 Serie Manual De Instrucciones

8 | Clamping
8.2

Areas of Application

The NC8 is supplied with clamping jaws and is suitable for conventional clamping.
Other clamping jaws are available from our range.
8.3

Information on the Jaws

NOTICE
Incorrect screw length and too high tightening torque.
Damage to the spindle and thread breakages.
Ø Do not exceed recommended tightening torque.
Ø Only use screws of a suitable size.
Unneeded threads must be closed with screw plugs.
8.4

Clamping the Workpiece

8.4.1

Between Surfaces

Fig. 21: Clamping between surfaces
When clamping between surfaces, no material displacement takes place, i.e. the clamping
force is built up extremely quickly.
62 / 410
ALLMATIC
NC8 Series