Ce Declaration Of Conformity - Genius SPRINT 382 Manual Del Usuario

1. WARNINGS
2. TECHNICAL SPECIFICATIONS
3. LAYOUT AND COMPONENTS
4. ELECTRIC CONNECTIONS
4.1. Connection of photocells and safety devices
4.2. J7 Terminal board - Power supply (fig. 2)
4.3. J6 Terminal board - Motors and flashing lamp (fig. 2)
4.4. J1 Terminal board - Accessories (fig. 2)
4.5. Connector J2 - Rapid connection to radio-receiver module
4.6. Connector J6 - Limit-switches rapid connection (fig.2)
4.7. Connector J3 - Encoder rapid connection (fig.2)
5. PROGRAMMING
5.1. BASIC PROGRAMMING
5.2. ADVANCED PROGRAMMING
6. START-UP
6.1. INPUTS CHECK
7. AUTOMATED SYSTEM TEST
Manufacturer: GENIUS S.p.A.
Address: Via Padre Elzi, 32 - 24050 - Grassobbio - Bergamo- ITALY
Declares that: Control unit model SPRINT 382
conforms to the essential safety requirements of the following EEC directives:
•
2006/95/EC Low Voltage directive.
•
2004/108/EC Electromagnetic Compatibility directive.
•
Additional information:
This product underwent a test in a typical uniform configuration (all products manufactured by GENIUS S.p.A.).
Grassobbio, 15 June 2008
The symbol indicates notes that are important for the safety of persons and for the good condition of the automated system.
The symbol
INDEX

CE DECLARATION OF CONFORMITY

Notes on reading the instruction
Read this installation manual to the full before you begin installing the product.
draws your attention to the notes on the characteristics and operation of the product.
11
page.12
page.12
page.12
page.12
page.13
page.14
page.14
page.14
page.15
page.15
page.15
page.15
page.15
page.15
page.17
page.17
page.17
Managing Director
D. Gianantoni