Layout And Components; Technical Specifications; Electric Connections - Genius SPRINT 382 Manual Del Usuario

1. WARNINGS
Before attempting any work on the control board (connections, main-
tenance), always turn off power.
Install, upstream of the system, a differential thermal breaker with
adequate tripping threshold.
Connect the earth cable to the appropriate terminal on the J7 con-
nector of the equipment (see fig.2).
Always separate power cables from control and safety cables (push-
button, receiver, photocells, etc.). To avoid any electric noise, use
separate sheaths or a shielded cable (with earthed shield).

2. TECHNICAL SPECIFICATIONS

Power supply
Absorbed power
Motor max. load
Accessories max. load
Operating ambient tempe-
rature
Protection fuses
Automatic / "Stepped" automatic / Semi-au-
tomatic / Safety devices / Semi-automatic B
Function logics
/ Dead-man C / "Stepped" semi-automatic
Work time
Pause time
Thrust force
Open / Pàartial opening / Safety devices
Terminal board inputs at opng. / Safety devices at clsng. / Stop /
Opening and closing limit-switches / Enco-
On-connector inputs
Flashing lamp - Motor - 24 Vdc accessories
Terminal board outputs power supply - 24 Vdc indicator-light / Timed
Rapid connector
Programming
Basic mode programmable Function logic - Pause time - Thrust Force
functions
Torque at initial thrust - Braking - Fail safe
- Pre-flashing - Indicator-light/Timed output -
Advanced mode program- Opening and closing safety devices logic -
mable functions Encoder - Decelerations - Partial opening
time - Work time - Assistance request - Cycle
CONTROL BOARD SPRINT 382
230 V~ ( +6% -10%) - 50 Hz
10 W
1000 W
0,5 A
-20 °C +55 °C
2 (see fig. 1)
/ Mixed Log. B+C
Programmable (from 0 to 4 min.)
Programmable (from 0 to 4 min.)
Adjustable over 50 levels
Edge / Power supply + Earth
der
output. - Fail safe
5-pin card connection for receivers
3 keys (+, -, F) and display, "basic" or
"advanced" mode
- Gate direction
counter

4. ELECTRIC CONNECTIONS

3. LAYOUT AND COMPONENTS

DL SIGNALLING AND PROGRAMMING DISPLAY
Led INPUTS STATUS CONTROL LED
J1 LOW VOLTAGE TERMINAL BOARD
J2 CONNECTOR FOR RECEIVER
J3 ENCODER CONNECTOR
J4 CAPACITOR CONNECTOR
J5 LIMIT -SWITCH CONNECTOR
J6 MOTORS AND FLASHING LAMP CONNECTION TERMINAL BOARD
J7 POWER SUPPLY TERMINAL BOARD 230Vac
F1 MOTORS AND TRANSF. PRIMARY FUSE (F 5A)
LOW VOLTAGE AND ACCESSORIES FUSE (T 800mA)
F2
F "F" PROGRAMMING PUSH-BUTTON
- "–" PROGRAMMING PUSH-BUTTON
+ "+" PROGRAMMING PUSH-BUTTON
12
Fig. 1 Fig. 1
* Only if don't use J4 connector * Only if don't use J4 connector
Fig. 2 Fig. 2