Packing List; Edger Attachment; Model Number Ea0800 - EGO EA0800 Manual Del Operador

Maintenance and storage
◾
Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working conditions.
◾
Replace worn or damaged parts.
◾
Do not attempt to repair the machine unless you are
competent to do so.
◾
Use only manufacturer-recommended replacement
parts and accessories.
◾
Disconnect the machine from the battery before
carrying out maintenance or cleaning work.
◾
Inspect and maintain the machine regularly. Have the
machine repaired only by an authorized repairer.
◾
When not in use, store the machine out of the reach
of children.
◾
If situations occur that are not covered in this manual,
use care and good judgment. Contact the EGO Service
Center for assistance.
◾
Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If
you loan this tool to someone else, also loan these
instructions to them to prevent misuse of the product
and possible injury.
SAVE THESE INSTRUCTIONS
NOTE: SEE YOUR POWER HEAD OPERATOR'S
MANUAL FOR ADDITIONAL SPECIFIC SAFETY RULES.
SPECIFICATIONS
Blade Length
Edging Depth
Weight
Measured sound power level L
WA
Sound pressure level at
operator's ear L
PA
Guaranteed sound power level L
(according to 2000/14/EC)
Front-assist Handle
Vibration a
h
Rear Handle
◾
The above parameters are tested and measured
equipped with power head PH1400E;
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
◾
NOTICE:
the power tool can differ from the declared value in
which the tool is used;In order to protect the operator,
user should wear gloves and ear protectors in the
actual conditions of use.

PACKING LIST

PART NAME

Edger Attachment

Hex Wrench
Multi-Functional Wrench
Cotter Pin
Operator's Manual
Recommended Blade
PART NAME
Edger Blade
DESCRIPTION
KNOW YOUR EDGER ATTACHMENT (Fig.A)
1. End Cap
20 cm
2. Edger Shaft
Up to 75 mm 3. Blade Guard
4. Blade
2.26 kg
5. Depth Adjusting Knob
92.4 dB(A)
6. Guide Wheel
K=2.07 dB(A)
7. Hex Wrench
8. Multi-Functional Wrench
79.8 dB(A)
9. Depth Adjusting Guide Bar
K=3 dB(A)
10. Debris Flap
95 dB(A) 11. Cotter Pin
WA
12. Screw to lock guide plate in place
1.2 m/s
2
13. Guide Plate
K=1.5 m/s
2
ASSEMBLY
2.2 m/s 2
K=1.5 m/s
2
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
The vibration emission during actual use of
WARNING:
If any parts are damaged or missing,
EDGER ATTACHMENT — EA0800
EN
QUANTITY
1
1
1
2
1
MODEL NUMBER
AEB0800
7