Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PTZ Mode
6. MODEL
This menu is for setting the PTZ camera ID and camera type.
At the [PTZ SETUP 1
] menu, press the
(see p.21).
Press the 1 button to move to the Model Setup screen.
Press a number in the number pad to set the PTZ camera ID.
The camera model type saved in EEPROM is displayed on the LCD monitor when changing
camera ID.
When entering '1'
Press the + and - buttons on the number pad to change the camera type.
Press the ENTER button to finish the setup.
26
SYSTEM CONTROLLER
button
User's Manual
7. TRACE
This menu is for inputting camera movements, through joystick or camera control
buttons, into the memory for a certain period of time, to allow repeating of stored
movements when performing the Trace (PATTERN) function.
Setting the TRACE SETUP menu by controller is only available for an SPD series.
In case of products by other manufacturers, the setting has to be done by the OSD
menu of the camera. See the camera manual for more information.
7-1. TRACE Memory
At the [PTZ SETUP 1
] menu, press the
(see p.20).
Press the 2 button to move to the Trace Setup screen.
Press the 1 button.
Use the joystick or camera control buttons to perform
the camera movement to input. Allowed movements
are horizontal movements (pan), vertical movements
(tilt), zoom, and focus controls.
Press the ENTER button to stop camera movement input.
• Maximum length for movement memory is approximately 60 ~ 105 seconds. This may
vary according to free memory space.
• Movement memory length may be shorter if the camera movement is more complicated.
• Press the FUNCTION button and the 2 button to start TRACE memory.Press the FUNCTION
button and the 3 button to stop TRACE memory. For more information, see p.12
7-2.TRACE Operation
At the Trace Setup screen, press the 2 button.
SYSTEM CONTROLLER
PTZ Mode
button
27
User's Manual
Publicidad
Tabla de contenido
