PTZ Mode
8. AF
This menu is for adjusting camera focus manually or automatically after camera
operation. If AF is set to OFF in the camera setup menu, set the AF of the controller to
ON and then automatic adjustment is performed after camera operation.
At the [PTZ SETUP 1
] menu, press the
(see p.21).
Press the 3 button to move to the AF Setup screen.
Press the 1 button to automatically adjust the focus
after camera operation. Press the 2 button to disable
automatic focus adjustment after camera operation.
• Auto Focus Setup is also available in the OSD menu
of the camera connected.
• It is recommended that you set up the AF function
through the camera OSD menu.
28
SYSTEM CONTROLLER
button
User's Manual
9. OSD
This is used for displaying the camera menu on the monitor.
Press the OSD button from the PTZ or DVR mode. (Warning: Execute only from the Master
controller).
Use the controller buttons to set up the camera menu.
- OSD
: SPD- Toggle camera menu on/off (hold down for 2 seconds)
PELCO-D - Toggle camera menu on/off
PELCO-P - Toggle camera menu on/off (press(ESC(PTZ))
PANASONIC - Toggle camera menu on/off (press ESC(PTZ))
Samsung Electronics - Toggle camera menu on/off (press ESC(PTZ))
ELMO - Toggle camera menu on/off
BOSCH - Toggle camera menu on/off (press(ESC(PTZ))
- ESC(PTZ)
: Cancels the menu selection.
- ENTER(PTZ) : Selects the menu.
-
: Moves the menu cursor right.
-
: Moves the menu cursor left.
-
: Moves the menu cursor up.
-
: Moves the menu cursor down.
- Joystick : Use the joystick to move the menu cursor up,
down, left, and right.(Panasonic and ELMO are not
supported.)
• Joystick or other button inputs cannot be used for camera operation when the camera
menu is displayed on the monitor.
• PRESET, SWING, GROUP, and TRACE functions can be set in the OSD menu of the camera.
• Please refer to the camera manual for more information on the camera menu.
SYSTEM CONTROLLER
PTZ Mode
only Samsung
techwin, Panasonic,
Samsung
Electronics,
ELMO model
29
User's Manual