Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Controller Mode
2. ID Setup
This menu is for setting controller ID.
At the [Controller SETUP 1 ] menu, press the 1 button
(see p.31).
Press a number on the number pad to enter a controller ID.
Press the ENTER button to set the controller ID.
• Assign number 1 for setting the controller ID for the
master controller.
• The lower the ID number, the higher the controller priority.
• Sub-controllers can be operated only when
connected to a master controller; Sub-controllers cannot be operated independently.
3. SERIAL Setup
This menu is for setting the serial port for connecting external devices to the controller.
At the [CONTROLLER SETUP 1
] menu, press the 2
button (see p.31).
Press the 1 button to activate the Serial 1 PORT Setup screen
(PTZ camera/DVR connection PORT). Press the 2 button to
activate the Serial 2 PORT Setup screen (reserved PORT).
• The value displayed at step indicates the current
setup value.
• The BAUD RATE/ DATA BIT/ STOP BIT/ PARATY BIT
for PORT 2, which connects to the sub-controller, are fixed and cannot bechanged.
The PORT Setup screen will be displayed. Press the
number for a setup menu.
1: Sets the BAUD RATE. (4800, 9600, 19200, 38400)
2: Sets the DATA BIT. (8BIT, 7BIT)
3: Sets the STOP BIT. (1BIT, 2BIT)
4: Sets the PARITY BIT. (NONE, ODD, EVEN)
• Default values for controller SERIAL are 9600 (BAUD RATE), 8BIT (DATA BIT), 1BIT (STOP
BIT) and NONE (PARITY BIT).
32
SYSTEM CONTROLLER
User's Manual
Controller Mode
4. DATA COPY
This menu is for copying master controller menu data to a sub-controller.
The controller ID value is not copied.
At the [CONTROLLER SETUP 1
] menu, press the 3
button (see p.31).
Press a number on the number pad to enter the ID number
for the subcontroller where the data will be copied.
Press the ENTER button to set the controller ID.
Press the 1 button to start coping data.
Press the 2 button to return to the previous menu.
The [DATA COPYING SUCCESS] message appears when data copying is complete.
The [DATA COPYING FAIL] message appears if data copying failed.
[DATA COPY SUCCESSFUL]
• Data copy takes approximately 7~10 seconds.
This menu is available only for the master controller (ID: 1).
SYSTEM CONTROLLER
[DATA COPY FAILURE]
33
User's Manual
Publicidad
Tabla de contenido
